Extreme Paints Industrial-Grade Polyurethane Floor Paint 20.0 kg

Extreme Paints Industrial-Grade Polyurethane Floor Paint is a heavy-duty, solvent-based floor coating specially engineered for tough industrial environments such as factories, warehouses, workshops, and high-traffic garage floors. This single-pack PU floor paint forms a durable, oil-resistant, and chemical-resistant surface that holds up against forklift traffic, tyre abrasion, impacts, and wear.

The anti-slip polyurethane variant is pre-mixed with fine silica particles, adding surface texture for improved traction on ramps and wet floors—ideal for loading docks and commercial kitchens. Easier to apply than two-part epoxies, this solvent-based polyurethane coating levels smoothly and delivers a long-lasting, high-gloss finish.

Manufactured in the UK under ISO 9001 QA protocols, each batch is viscosity-checked to ensure colour consistency and coverage. Always in stock for rapid dispatch—perfect for time-sensitive projects where large industrial floor areas need immediate coating.

Suitable Substrates

• Bare or sealed concrete (must be dry and properly prepared)
  

• Ground power-floated or polished concrete
  

• Prepared metal surfaces
  

• Sound timber floors
  

• Most porous masonry surfaces
  

Note: Avoid using on self-levelling screeds unless tested—most are non-porous and not ideal for solvent-based PU coatings.

Primer Required: Apply Extreme Paints Clear Polyurethane Primer & Sealer to bare, porous, or mechanically ground concrete for optimal adhesion and penetration.

Available Colours

• Black
  

• Dark Grey
  

• Grey
  

• Light Grey
  

• Mid Green
  

• Dark Green
  

• Post Office Red
  

• Red
  

• JCB Yellow
  

• Orange
  

• Blue
  

• White
  

Custom RAL or BS shades available on orders ≥ 100 litres.

Coverage & Spread Rate

• 5–7 m² per litre per coat (varies by surface porosity)
  

• 5 L tin ≈ 15 m² (2 coats)
  

• 20 L tin ≈ 60 m² (2 coats)
  

Drying & Curing Times (@ 18 °C)

• Touch dry: 6–8 hours
  

• Recoat: 6–8 hours
  

• Light foot traffic: 24 hours
  

• Forklift/vehicle use: 72 hours
  

• Full cure (chemical resistance): 7 days
  
  

 Storage & Thinning

• Store between 5 °C and 30 °C in sealed containers
  

• Use white spirit or PU thinner (≤ 5%) for spray application
  

• Order total required volume in a single batch to ensure colour consistency
  
  

Application Instructions

1. Surface Preparation

• Remove all loose paint, grease, dust, or debris
  

• Substrate moisture should be below 4%
  

• Mechanically grind power-floated concrete
  

• Avoid painting over damp surfaces
  

2. Priming

• Use Extreme Paints Polyurethane Primer & Sealer on bare, porous or brittle concrete
  

3. Mixing

• Stir thoroughly for 3 minutes with a paddle mixer
  

• For the anti-slip version, ensure silica grit is evenly dispersed
  

4. Application Method

• Brush or roller for both finishes
  

• Airless or HVLP spray for a smooth gloss finish only
  

• Do not spray anti-slip variant—grit will clog nozzles
  

• Apply two thin coats at right angles for best coverage
  

5. Curing

• Wait 6–8 hours between coats
  

• Allow 24 hours for foot traffic
  

• Forklift-safe after 72 hours
  

Fully cured, chemical-resistant surface in 7 days